Publicité
Les langues disponibles
Les langues disponibles
Operation
Securing supply cables and plugs
Fig. 9: Securing cables and plugs
b The lever A (Fig. 9) is closed.
1. Insert the plug B (Fig. 9) into the control unit
until resistance is first felt.
2. Lift the lever A.
3. Push in the plug B fully.
4. Close the lever A.
5. Secure the plug B to the control unit using screw
C (Fig. 9).
1. Time of printing. Further information is available from your authorized Porsche dealer.
14
Operation
Operating instructions
NOTE
Risk of damage to the charger
e
Always place the charger on a solid surface when
charging.
e
Porsche recommends using the charger in the
wall mount. In some countries, e.g. Switzerland
the charger may only be used in the Basic wall
mount.
g Refer to chapter "Installing the wall bracket" on
page 8.
e
Do not immerse the charger in water.
e
Protect the charger from snow and ice.
e
Protect the charger against potential damage
through being driven over, dropped, pulled, bent
or crushed.
The charger must only be operated within a temper-
ature range from –22 °F to +122 °F (-30 °C to
+50 °C).
Information
−
To prevent overheating during operation, avoid
continuous exposure of the charger to direct
sunlight. If the control unit overheats, charging
is interrupted or the power is reduced automati-
cally until the temperature has returned to the
normal range.
−
When driving abroad, always carry the appropri-
ate supply cable for the country you are visiting
with you.
1
,
−
Different safety concepts are prescribed with
different device variants depending on the coun-
try. Before traveling abroad, make sure that the
charger can also be used in the relevant coun-
try. Further information is available from your
authorized Porsche dealer or the local electricity
supplier.
Publicité
