Stryker 1020 Manuel D'utilisation page 5

Introduction
Before operating this stretcher, it is important to read and understand all information in this manual. Carefully
read and strictly follow the warnings listed on this page.
WARNING
To avoid damage, remove any equipment that may be in the way before raising or lowering the litter height.
Always apply the caster brakes when a patient is getting on or off the stretcher. Push on the stretcher to en-
sure the brakes are securely locked. Always engage the brakes unless the stretcher is being moved. Injury
could result if the stretcher moves while a patient is getting on or off the stretcher.
To avoid injury or damage to the equipment, do not allow the siderail to lower on its own.
The push handles were designed for use while transporting the stretcher. Avoid using other parts of the
stretcher as push devices as damage may occur.
When using the transfer board to transfer a patient, always lock the brakes on all stretchers, beds, etc. being
used and always be certain the transfer board is placed securely on the surface of the mating stretcher or
bed. The patient stretcher and the mating surface must be at the same height before the patient is transferred.
Keep hands/fingers clear of area between spine tubes and Fowler when lowering. Injury could result.
To avoid damage, the weight of the I.V. bags should not exceed 40 pounds.
To avoid damage while transporting the stretcher, verify the I.V. pole is at a low enough height to allow it to
safely pass through door openings and under light fixtures.
CAUTION
The unit cannot be raised (hydraulics on base) with a patient lift under the stretcher.
The hood may not be used for stepping.
Note
Clean hood storage area regularly.
The bottom of the brake rings should be cleaned regularly to prevent wax and/or floor remnant buildup.
1−3