Stryker 1020 Manuel D'utilisation page 13

USING THE PATIENT TRANSFER BOARD/ARM BOARD (CONTINUED)
Using the Transfer Board as an armboard:
OPERATING THE FOWLER
1. Squeeze handle (A) for pneumatic assist in lifting the Fowler to the desired height. Remove hand(s) from
handle when desired height is achieved.
2. To lower, squeeze handle (A) and push down until Fowler has reached desired height. Remove hands from
handle when desired height is achieved.
WARNING
Keep hands/fingers clear of area between spine tubes (B) and Fowler when lowering. Injury could result.
Stretcher Operation
1. Raise the support post (D) to the up position.
2. Raise the transfer board (C) from the bottom while lifting
from the top.
3. When the transfer board is fully raised, it can be pivoted
downward onto the support post (D).
CAUTION
When the transfer board is being used to transfer a patient,
the support post (D) must be in the stored (down) position.
Damage to the support post will occur if it is pushed up
against a stretcher, table, etc.
B
1−11
A