0.5 - HAZARDOUS ZONES
• The climate controllers must not be installed in environments with the presence
of inflammable gases, explosive gases, in very humid environments (laundries,
greenhouses, etc.), or in places with other machines that generate a strong heat
source, in proximity of a sources of salt water or sulphurous water.
• DO NOT use gas, gasoline or other inflammable liquids near to the climate
controller.
• Only use supplied components (see paragraph 1.1). The use of non-standard
parts may cause water leaks, electric shocks, fires and injuries or damages to
things.
This product must be used exclusively according to the specifications
indicated in this manual. Use different to that specified, could cause serious
injuries.
THE MANUFACTURER IS NOT LIABLE FOR INJURY/DAMAGE TO
PERSONS/OBJECTS DERIVING FROM FAILURE TO COMPLY WITH THE
REGULATIONS CONTAINED IN THIS MANUAL.
* Only for version with heat pump
0.6 - WARNINGS FOR R290 REFRIGERANT GAS
1.
THE APPLIANCE CONTAINS R290 GAS (FLAMMABILITY CLASSIFICATION A3).
2.
THE APPLIANCE SHALL BE STORED IN A WELL-VENTILATED AREA WHERE THE ROOM
SIZE CORRESPONDS TO THE ROOM AREA AS SPECIFIED FOR OPERATION.
3.
THE APPLIANCE MUST BE INSTALLED, USED AND STORED IN A ROOM WITH A FLOOR
SURFACE HIGHER THAN THE ONE INDICATED IN THE CHART.
Quantity of R290 gas in Kg
(see data label on the appliance)
Minimum size of the site
for use and storage (m
4.
THIS APPLIANCE CONTAINS A QUANTITY OF REFRIGERANT GAS R290 EQUAL TO THE
ONE INDICATED IN THE DATA LABEL LOCATED ON THE APPLIANCE.
5.
THE APPLIANCE SHALL BE STORED IN A ROOM WITHOUT CONTINUOUSLY OPERAT-
ING IGNITION SOURCES (FOR EXAMPLE: OPEN FLAMES, AN OPERATING GAS APPLI-
ANCE OR AN OPERATING ELECTRIC HEATER).
6.
Do not pierce or burn.
7.
Be aware that the refrigerants may not contain an odour.
8.
R290 is a refrigerant gas in compliance with the European directives on environment. Do not
pierce any part of the refrigerant circuit.
9.
Do not use means to accelerate the defrosting process or to clean, other than those recom-
mended by the manufacturer.
10. Do not use tools different from those recommended by the manufacturer when defrosting and
cleaning the appliance.
11. If the appliance is installed, used or stored in a non-ventilated area, the room must be de-
signed to prevent the accumulation of refrigerant leaks with the consequent fire or explo-
sion hazard due to the refrigerant combustion caused by electrical heaters, stoves or others
sources of ignition.
12. Compliance with national gas regulations shall be observed.
13. Keep ventilation openings clear of obstruction.
14. The appliance shall be stored so as to prevent mechanical damage from occurring.
EN - 6
0,180 0,190 0,200 0,210 0,220 0,230 0,240 0,250 0,260
9
10
)
2
10
11
11
12
12
12
13