Wiring The Accessories 3; Photoelectric Cells; Orange Light - SOMFY SLIDYMOOVE Manuel

For your safety, these operations must be carried out with the power supply switched off.
You are advised to perform auto-programming of the gate travel before connecting the accessories
(photoelectric cells, orange light, etc.)

3.1 Photoelectric cells

It is not possible to connect a second set of photoelectric cells on this drive.
TX
RX
1 2 1 2 3 5
TX
RX
1 2
1 2

3.2 Orange light

10 W - 24 V bulb MAXIMUM - use of a bulb with power greater than 10 W- 24 V can cause drive
malfunctions.

WIRING THE ACCESSORIES 3

Wiring the accessories
Installation
A er wiring the photoelectric cells:
• switch the motor on again,
• start a gate opening or closing procedure.
The photoelectric cells are recognised by the
control electronics once this movement is
complete.
Operation with photoelectric cells
If the cells are blocked when closing the gate,
the gate will stop and reopen.
Operation of the orange light
The orange light flashes while the gate is moving.
EN- Replacing the SLIDYMOOVE electronic unit - SOMFY
3
8