Wiring The Accessories; Photoelectric Cells; Orange Light - SOMFY FREEVIA Mode D'emploi

3

WIRING THE ACCESSORIES

For your safety, these operations must be carried out with the power supply switched off.
You are advised to perform auto-programming of the gate travel before connecting the accessories
(photoelectric cells, orange light, etc.)

3.1 Photoelectric cells

It is not possible to connect a second set of photoelectric cells on this drive.
TX
RX
1 2
1 2 3 5
In the event of photoelectric cell disconnection
A er disconnecting the photoelectric cells, switch the engine on again then perform the procedure
"Deactivating automatic closing - returning to standard operation" page 13.

3.2 Orange light

10 W - 24 V bulb MAXIMUM - use of a bulb with power greater than 10 W- 24 V can cause drive
malfunctions.
Installation
A er wiring the photoelectric cells:
• switch the motor on again,
• start a gate opening or closing procedure.
The photoelectric cells are recognised by the
control electronics once this movement is
complete.
Operation with photoelectric cells
If the cells are blocked when closing the
gate, the gate will stop and reopen.
Operation of the orange light
The orange light flashes while the gate is moving.
EN - Replacing the FREEVIA electronics unit - SOMFY
9