Roger Technology B70/2DC Instructions Et Consignes Pour L'installateur page 52

Enable limit switches
N.B.: This parameter is visible only if
No limit switch installed.
Gate open limit switches installed.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when opening.
Contact with 8k2 resistor. The gate reverses only when opening.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
N.B.: This parameter is not visible if
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when closing.
Contact with 8k2 resistor. The gate reverses only when closing.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
STEP MODE.
OPENING
CLOSING.
STOP.
remote control is active. The parameter
The remote control turns the courtesy light on and off. The parameter
(1)
mand. Example: parameters
•
Selecting courtesy light mode
Disabled.
ACTIVE. The light remains lit for the entire duration of the manoeuvre.
52
COS1
COS2
is ignored.
(1)
(1)
(1)
and set:
.
and .
(1)
is ignored.