Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8
Travel acquisition
For the system to function correctly, the gate travel must be acquired by the control.
Before starting:
1. Select the automation system model installed with the parameter
2. Select the number of motors installed with the parameter
3. Check that the operator present function is not enabled (
4. Install mechanical stops in both the open and closed positions.
5. Move the gate into the closed position.
6. Press TEST (see TEST mode in chapter 7) and check the command signal and safety device states. If any safety
devices are not installed, jumper the relative contact or disable the device from the relative parameter ( ,
,
and
).
ACQUISITION PROCEDURE:
TEST
CHIUSO
CLOSED
PROG
PROG
AP P-
x4 s
1 click
x2 s
AU to
AU to
• Press and hold PROG for 4 seconds.
• Press PROG again.
•
starts opening at low speed.
• After the delay time set with parameter
•
for 2 s.
• When the message
setting of 3 s) and then, after a delay set with parameter
closed mechanical stop is reached.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
•
: acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
•
: travel length error. Press the TEST button to clear the error, and check that both gate leaves are completely
closed.
For more information, see chapter 13 "Alarms and faults".
44
TEST
23
No
Yes
Sì
TEST
00
1
AU to
MOTORE 1
APERTURA
OPENING
2
MOTORE 2
PARAM. 26
CLOSING
CHIUSURA
is shown on the display.
is shown on the display.
. The default setting for this parameter is motor
. This parameter is set for two motors by default.
).
See safety input (Chap. 12) and
Vedi capitoli segnalazioni 12 e 13
Alarm and fault (Chap. 13)
PARAM. 25
OPENING
2
1
CLOSED
MOTORE 1
CHIUSO
CLOSING
CHIUSURA
2
1
OPEN
MOTORE 2
APERTO
APERTURA
,
,
Yes
Sì
Publicité
Table des Matières
