Test Mode; Standby Mode - Roger Technology B70/2DC Instructions Et Consignes Pour L'installateur

7.3 TEST mode

To activate the mode, press the TEST button with the automatic gate system at rest. If the gate is moving, pressing
TEST stops the gate. Pressing the button again enables TEST mode.
device is activated.
appear on the display.
Example: STOP contact in alarm state.
NOTE: If one or more contacts are open, the gate will not open or close. This does not apply for the limit switch signal
state, however, which is shown on the display but does not prevent normal operation of the gate.
the next device is displayed. Any further alarm states are also displayed with the same logic.
Press the TEST button again to exit test mode.
After 10 seconds with no user input, the display returns to command and safety device state display mode.

7.4 Standby mode

Press UP , DOWN , + , - to reactivate the control unit.
POWER
No safety device in alarm state, and no limit switch activated
STOP.
Sensing edge COS1.
Sensing edge COS2.
Photocell FT1.
Photocell FT2.
Gate open limit switch
Gate open limit switch
Serie ).
).
43