Roger Technology B70/2DC Instructions Et Consignes Pour L'installateur page 53

From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.
From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
N.B.: This parameter is not visible if
When the clock function is active, the gate opens and remains open. Any command signal received is
ignored.
When the clock function is active, the gate opens and remains open. Any command signal received is
accepted. When the gate returns to the completely open position, the clock function is reactivated.
Enable safeguarded gate closure/opening
command.
This function is NOT enabled if:
• the gate receives a STOP command;
• the sensing edge is activated;
• the number of closure attempts set by parameter
• the acquired position is lost (perform position recovery, see chapter 16).
Disabled. The parameter
Safeguarded closure enabled.
After a period of time set with parameter
light, regardless of the parameter
If the gate is closed as a result of a step mode command, after a period of time set with parameter
then the gate closes.
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after
a period of time set with parameter
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes
after a period of time set with parameter
Setting safeguarded closure/opening activation time
N.B.: this parameter is not visible if the value of parameter
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
P1
P2
Warning!
that all parameters are suitable for the installation.
The default factory settings may also be restored using the
• Turn off the power.
• Press and hold the (up arrow) and
• The display flashes after 4 s
• The default factory settings have now been restored.
(ORO)
and
is not displayed.
, and then closes the gate.
.
.
x4 s
(down arrow) button until the unit switches on.
.
.
has been reached;
= .
(up arrow) and (down arrow) buttons as follows:
,
), and
: after restore, check
53