Travel Acquisition; Before Starting - Roger Technology B70/2ML Instructions Et Consignes Pour L'installateur

10

Travel acquisition

For the system to function correctly, the gate travel must be acquired by the control.
10.1

Before starting

1. Select the automation system model installed with the parameter
KEY: HIGH SPEED Motor
SELECTION
AYRON SERIES
BE20/200
MONOS4
2. Select the number of motors installed with the parameter
3. Check that the operator present function is NOT enabled (
4. Install mechanical stops in both the open and closed positions.
5. Move the gate into the closed position. The gate leaves must be against the mechanical stops.
6. Press TEST (see TEST mode in chapter 8) and check the command signal and safety device states. If any safety
devices are not installed, jumper the relative contact or disable the device from the relative parameter ( ,
, and ).
60
MODEL
OPEN
.
MOTOR
TYPE
NOTE: for gate leaves up to 2.5 m
-
NOTE: for gate leaves up to 3 m
-
NOTE: for gate leaves up to 4 m
. This parameter is set for two motors by default.
).
STOP CLOSE
CONFIGURATIONS
, ,