Parameters Menu - Roger Technology B70/2ML Instructions Et Consignes Pour L'installateur

12

Parameters menu

PARAMETER
PARAMETER
VALUE
Selecting automation system model
WARNING! If this parameter is not set correctly, the automation system may not function properly.
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
AYRON SERIES - IRREVERSIBLE HIGH-SPEED gear motor with articulated arm
BE20/200 - IRREVERSIBLE arm piston with worm screw
MONOS4 - IRREVERSIBLE telescopic arm piston
Automatic closure after pause time (from gate completely open)
Disabled.
From 1 to 15 of gate closure attempts after photocell is triggered.
Once the number of attempts set is reached, the gate remains open.
Automatic gate closing after mains power outage
Disabled. The gate does not close automatically when mains power is restored.
Enabled. If the gate is NOT completely open, when mains power is restored, the gate closes after a 5 second warning
The gate closes in "position recovery" mode (see chapter 17).
Selecting step mode control function (PP)
The automatic closing timer restarts if a new step mode command is received.
Step mode commands are ignored while the gate is opening. This allows the gate to open completely and prevents the
gate from closing when not required.
If automatic closing is disabled (
The automatic closing timer does NOT restart if a new step mode command is received.
Step mode commands are ignored while the gate is opening. This allows the gate to open completely and prevents the
gate from closing when not required.
If automatic closing is disabled (
Flashing warning signal for 1 to 10 seconds prior to every manoeuvre.
Condominium function for partial open command (PED)
Enabled. Partial commands are ignored during gate opening.
Enabling operator present function
Disabled.
Enabled. The open (AP) or close (CH) button must be pressed continuously to operate the gate. The gate stops when
the button is released.
), the condominium function automatically attempts a closing manoeuvre
), the condominium function automatically attempts a closing manoeuvre
).
.
.
65