Integrated Descaling Programme - Melitta Caffeo SOLO Guide D'utilisation

→ The Integrated Cleaning programme has finished.
the standby symbol
the appliance is ready for operation.

Integrated Descaling programme

the integrated descaling programme removes limescale in the interior of the ap-
pliance. It takes a total of approximately 30 minutes. the symbol for descaling
flashes during the entire process.
Prerequisite: The appliance must be switched off. Remove the Melitta
Claris water filter - if present - from the water reservoir before descal-
®
ing.
Caution!
– execute the integrated descaling programme every 3 months or when
the symbol for descaling
– Only use the Melitta
decalcifying agent is precisely matched to the Melitta
–
Never use vinegar or other descaling agents.
Run the Integrated Descaling programme as follows:
Phase 1
During Phase 1, one bean symbol
1 simultaneously press the button for steam dispensing
Off button
→ the symbol for descaling
illuminated.
2 empty the drip tray and then re-insert it without coffee grounds contain-
er, and place the coffee grounds container under the steam pipe.
→ the symbol for the water reservoir
3 Pull the water reservoir up and out of the appliance and empty it com-
pletely.
74
is illuminated after a brief heat-up phase.
is illuminated in the display.
decalcifying agent for automatic coffeemakers. this
®
is shown on the display.
for more than 2 seconds.
flashes and the symbol for the drip tray
sOLO
®
is illuminated.
®
&milk.
®
and the On/
is