Melitta Caffeo SOLO Guide D'utilisation page 74

Phase 2
During Phase 2, one bean symbol
→
First, two automatic rinsing processes will be executed. the standby symbol
will then be illuminated.
5 Reach into the recess on the right side of the appliance (Fig. A, no. 13) and
pull off the cover to the right.
6 Press and hold the red button on the handle of the brewing unit (Fig. B,
no. 1) and turn the handle clockwise to the stop (approximately 75°).
7 use the handle to pull the brewing unit out of the appliance.
→
the standby symbol
as long as the brewing unit is out of the machine.
Caution!
Danger of damaging the brewing unit
–
During the cleaning programme only remove the brewing unit at the
time specified here.
8 Leave the brewing unit as it is (do not move or twist the components of
the brewing unit).
9 thoroughly rinse off the entire brewing unit from all sides under running
water and let it drip off.
10 Place a cleaning tab in the brewing unit (Fig. C).
11 Insert the brewing unit back into the appliance and turn the handle of the
brewing unit anticlockwise to the stop to lock.
→ the symbol for cleaning
not illuminated. the symbol for the water reservoir
12 Insert the four catches of the cover in the back of the appliance and swing
the cover to the left until it engages.
→ Phase 2 is completed.
72
is shown on the display.
and the symbol for cleaning
will continue to flash; the standby symbol
will flash alternately,
is
is illuminated.