Integrated Descaling Programme - Melitta Caffeo Bistro Guide D'utilisation

11.5 Integrated descaling programme

The integrated descaling program removes lime scale in the interior of the
appliance. It takes a total of approximately 15 minutes. The symbol for descaling
flashes during the entire process.
Prerequisite: The appliance is in stand-by mode (see „Switching on and off"
on page 54).
Caution!
– Carry out the integrated descaling programme every 3 months or when the
descaling symbol
– Only use Melitta
cleaning tabs are specifically designed for the Melitta
– Never use vinegar or other descaling agents.
Run the integrated descaling programme as follows:
1 Before descaling, remove – if necessary – the Melitta
filter from the water tank (see page 55).
2 Press the button for two-cup dispensing
simultaneously for about 3 seconds.
→ The descaling symbol
Phase 1
During Phase 1, one bean symbol
3 Empty the drip tray and coffee grounds container.
4 Reinsert the drip tray without the coffee grounds container, and place
the coffee grounds container under the Perfect Cappuccino.
→ The symbol for the water reservoir
5 Lift the lid of the water tank (Fig. A, no. 3) and pull the water tank up
and out of the appliance and then empty it completely.
6 Add the descaling agent (e.g. Melitta
liquid descaling agent) to the water tank according to the instructions on
the packaging.
Heft_Caffeo_Bistro_EU_2.2.indd 71
illuminates on the display.
ANTI CALC Espresso Machines descaling agent. These
®
and the drip tray symbol
is shown on the display.
CAFFEO
®
Claris
®
and the ON/OFF button
illuminate.
illuminates.
ANTI CALC Espresso Machines
®
.
®
water
®
71
09.04.2014 14:33:55