Integrated Descaling Programme - Melitta Caffeo CI Mode D'emploi

Integrated descaling programme

Warning!
The descaling agent can cause skin
irritations
Comply with the safety instructions
and the dosing information specifi ed
on the descaling agent packaging.
The integrated descaling programme
(takes about 25 minutes) removes lime
residues inside the appliance. The
progress bar on the graphic display 4
shows the current progress of the cleaning
programme.
The descaling programme should be
performed every 3 months, at the latest,
however, when a corresponding message
appears on the graphic display 4.
Only use Melitta
®
• Call up the Care sub-menu.
• Select Descaling in the menu.
• Select Start in the menu. The descaling
programme will start.
• When the message "Empty tray
and vessel" appears on the graphic
display 4, empty the the drip tray and the
coffee grounds container and reinsert
them.
• When the message "Remove water
tank" appears on the graphic display 4,
fl ip up the lid of the water reservoir 6 and
pull the water reservoir 6 up and out of
the appliance, and empty it.
• If a water fi lter is used, remove it from
the water reservoir.
• Add the descaling agent to the water
reservoir according to the instructions on
the packaging.
• Reinsert the water reservoir 6.
34
BA_CI_042015.indd 34 BA_CI_042015.indd 34
ANTI CALC.
• Place a vessel (min. 0.7 l capacity)
under the outlet 3.
• Press the rotary switch 10 to confi rm.
• Connect the tube to the drip tray and to
the outlet (Image D).
• Press the rotary switch 10 to confi rm.
The descaling programme will continue
(approx. 20 minutes), water fl ows out of
the outlet and in the drip tray inside the
appliance.
• When the message "Empty tray
and vessel" appears on the graphic
display 4, empty the vessel under the
outlet and the drip tray. Then reinsert
them both.
• When the message "Refi ll water tank"
appears on the graphic display 4, fl ip up
the lid of the water reservoir 6 and pull
the water reservoir 6 up and out of the
appliance.
• Rinse the water reservoir 6 thoroughly.
• Fill the water reservoir 6 with tap water
up to the max. mark.
• Reinsert the water reservoir 6.
• The descaling programme will continue
(approx. 5 minutes), water fl ows out of
the outlet and in the drip tray inside the
appliance.
• When the message "Empty tray
and vessel" appears on the graphic
display 4, empty the vessel under the
outlet and the drip tray. Then reinsert
them both.
• After the descaling programme is
fi nished, the appliance is ready for
operation.
20.04.2015 20:45:12 20.04.2015 20:45:12