Fitting Instructions - R&G CP0431BL Mode D'emploi

Picture 29
Picture 31

FITTING INSTRUCTIONS

•
To remove the left side fairing on the bike, remove the six bolts that are arrowed in picture 1.
•
Remove the bolt that secures the rear of the infill panel, as arrowed in picture 2.
•
Remove the push rivet on the front corner of the infill panel behind the headlights, as arrowed
in picture 3.
•
The infill panel can now be removed, as shown in picture 4. Repeat the above three stages to
remove the fairing bolts and infill panel on the right side of the bike.
•
Remove the four push rivets that secure the radiator cowl in place on the left side of the bike,
as shown in pictures 5, 6 & 7, before removing the cowl from the bike. Repeat this procedure
to remove the right side radiator cowl.
•
Remove the mirrors from the bike by disconnecting the wiring connector for the indicators
and then removing the two nuts that secure the indicator in place, as shown in picture 8.
•
Remove the mirror whilst feeding the connector and wiring out from the hole, as shown in
picture 9. Repeat for the other side.
•
On the right side of the bike, remove the bolt that is arrowed in picture 10.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com
CP0431
Picture 30
Picture 32
Email: info@rg-racing.com