Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
15.2
Calling up programs
•
Press the
key. The parameters RCL is displayed.
PROG
•
Use the adjusting knob
If a "+" is shown after the program location, then this data is write-protected.
•
Press the
key. Briefly, Program recall ... is displayed as confirmation.
START
The centrifugation data of the selected program place is shown.
15.3
Write protection for programs
The programs can be protected against unintentional modification.
The write protection can be activated/deactivated as follows when the rotor is at a standstill:
•
Call up the desired program (see the chapter on "Calling up programs").
•
Press the
key. The parameters RCL is displayed.
PROG
•
Press and hold the
PROG
After eight seconds, Set Protection = 1- (for example) appears in the display.
•
Set
"+" or "-" with the adjusting knob.
+ = program is write-protected,
- = program is not write-protected.
•
Press the
button to save the setting.
START
15.4
Program linkage
"Program linkage" can be used to link several centrifuge operations together.
A program linkage is only possible if this has been activated (parameter Multi programs = on; see the
chapter on "Activating or deactivating program linkage").
15.4.1
Activating or deactivating program linkage
The program link can be activated/deactivated as follows when the rotor is at a standstill:
•
Press and hold the
PROG
After eight seconds, ∗∗∗ Machine Menu ∗∗∗ appears in the display.
•
Press the
key as often as necessary until the ->Settings is displayed.
PROG
•
Press the
key. The SOUND / BELL = off/on is displayed.
START
•
Press the
key as often as necessary until the Multi programs = off/on is displayed.
PROG
•
Set off or on with the adjusting knob
off = program linkage deactivated,
on = program linkage activated.
•
Press the
key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.
•
Press the
key once to leave the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
15.4.2
Linking programs or changing a program linkage
It is possible to save 25 program linkages (program locations A to Z; there is no program location J). A
program linkage can consist of no more than 20 programs.
The speed adjustment from one program to the next one is always done in a program linkage with the start-up
parameter of the next program.
There cannot be any continuous operation programs in a program linkage.
No centrifuge parameters may be modified in a program linkage. A parameter modification is only possible in
the individual programs.
The
button can be used during the centrifuge operation to call up the total run time of the program
TIME
linkage
(e. g. ∑=00:05:30) and the run time of the currently running program (e.g. t B.02=00:01:00).
1.
Press the
button repeatedly until the parameter EDIT A...Z is displayed.
PROG
2.
Use the
adjusting knob to set the desired program location where the program linkage is to be saved.
3.
Press the
button. The program location of the program linkage and the first program of the program
START
linkage will be shown (e.g. EDIT B.01 = 01).
4.
Use the
adjusting knob to set the first program of the program linkage.
5.
Press the
button. The next program of the program linkage will be shown (e.g. EDIT B.02 = END).
PROG
to set the program place you want.
button for eight seconds.
button for eight seconds.
.
key twice to leave the
OPEN / STOP
EN
43/108
Publicité
Chapitres
Table des Matières
