Options And Accessories - Hatco Flav-R 2-Go F2G Série Manuel D'installation Et D'utilisation

OPTIONS AND ACCESSORIES

Wall Mount Bracket Installation
Use the following procedure to secure the top of a floor mount
model to the wall using the wall bracket accessory.
1. Install the two included mounting brackets to the wall
bracket using the supplied screws and nuts.
• Use the inner holes on the wall bracket for two column
models. Use the outer holes on the wall bracket for
three column models.
Inner Hole
Outer Hole
Mounting
Bracket
Installing the Mounting Brackets
2. Install the wall bracket assembly to the unit.
a. Loosen the two screws an 1/8" on each of the
appropriate half disc brackets on the unit.
b. Slide the mounting brackets on the wall bracket
assembly onto the loosened screws.
c. Tighten the screws to secure the wall bracket assembly
to the unit.
Installing the Bracket to the Unit
3. Complete steps 1‒8 of the "Installing Floor Mount Models"
procedure in the INSTALLATION section to secure the
front of the unit to the floor.
Screw
Wall Bracket
Nut
Wall Bracket
Assembly
Half Disc
Bracket
Mounting
Bracket
4. Secure the unit to the wall using the appropriate fasteners
through the holes in the wall bracket assembly and into the
wall.
• Locate the studs in the wall to determine which wall
bracket holes need to be used for proper installation into
studs.
• Make sure the wall bracket assembly mounting holes are
flat against the wall. If adjustments are needed, loosen
the mounting bracket screws, slide the wall bracket into
position, and re-tighten the screws.
Installing the Unit to the Wall
5. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
Touchscreen Controller Location
The touchscreen controller can be ordered on the left, right, or
center column. The locations available differ depending on the
model.
Cord Location
The power cord and plug can be ordered on the left or right side
of the unit depending on the model.
18
English
Wall Bracket Assembly
Form No. F2GM-0820