Open A Locker Manually; Clear A Single Order; Change A Locker's Heated/Ambient Setting; Change All Lockers' Heated/Ambient Setting - Hatco Flav-R 2-Go F2G Série Manuel D'installation Et D'utilisation

English

Open a Locker Manually

Use this procedure to open a locker manually if the order wasn't
removed within 20 seconds.
1. On the Select Lockers screen, touch a locker number to open.
2. With the locker selected, touch LOCKER SETTINGS.
3. Enter the Passcode and touch ENTER to access the
Locker Settings screen.
• The factory set Passcode is: 88888
88888
Passcode Screen
4. On the Locker Settings screen, touch OPEN LOCKER.
• The LED lights for the corresponding locker will flash
three times, then stay illuminated while the locker
remains unlocked.
5. Open locker with flashing lights and remove food.
• The locker will remain unlocked for 20 seconds. The
LED lights will flash white light three times and stay
illuminated while the locker is unlocked.

Clear a Single Order

Use this procedure to clear an order.
1. On the Select Lockers screen, touch a locker number with
the order you want to clear.
2. With the locker selected, touch LOCKER SETTINGS.
3. Enter the Passcode and touch ENTER to access the
Locker Settings screen.
• The factory set Passcode is: 88888
4. On the Locker Settings screen, touch CLEAR ORDER.
NOTE: Clearing an order will clear the order from the selected
locker and all other lockers linked to the same order.

Change a Locker's Heated/Ambient Setting

Use this procedure to change a single locker's Heated/Ambient
setting.
1. On the Select Lockers screen, touch the desired locker
number to change the Heat/Ambient selection of that locker.
2. With the locker selected/highlighted, touch LOCKER
SETTINGS.
3. Enter the Passcode and touch ENTER to access the
Locker Settings screen.
• The factory set Passcode is: 88888
Form No. F2GM-0820
Locker Settings Screen
4. On the Locker Settings screen, touch AMBIENT or HEATED.
• Ambient selection will turn the heating elements off for
that locker.
• Heated selection will turn the heating elements on for
the locker.
• Allow the locker 30 minutes to reach operating
temperature.
5. Touch to return to the Select Lockers screen.

Change All Lockers' Heated/Ambient Setting

1. On the Select Lockers screen, touch
2. Enter the Passcode and touch ENTER to access the
System Settings screen.
• The factory set Passcode is: 88888
3. On the "Set All Lockers" line, touch the
to toggle between "Ambient", "Heated", and "No Change"
selections.
• "No Change" keeps the ambient or heated setting for
individual lockers made in the "Change a Locker's
Heated/Ambient Setting" procedure.
• "Ambient" turns off ALL of the heating elements inside
each locker.
• "Heated" turns on ALL of the heating elements inside
each locker.
System Settings Screen
4. Touch the to return to the Select Lockers screen.
13
OPERATION
for system settings.
or arrow