Change The Temperature Setpoint; Change The Color Of Led Lights; Updating The Touchscreen Controller Software - Hatco Flav-R 2-Go F2G Série Manuel D'installation Et D'utilisation

English

Change the Temperature Setpoint

1. On the Select Lockers screen, touch
2. Enter the Passcode and touch ENTER to access the
System Settings screen.
• The factory set Passcode is: 88888
88888
Passcode Screen
3. On the "Heated Set Point" line, touch the
to increase or decrease the temperature setpoint.
• The temperature setpoint changes in increments of 1°
and can be set up to 180°F (82°C).
System Settings Screen
4. Touch the to return to the Select Lockers screen.

Change the Color of LED Lights

1. On the Select Lockers screen, touch
2. Enter the Passcode and touch ENTER to access the
System Settings screen.
• The factory set Passcode is: 88888
3. On the "Background Lock Color" line, touch the
arrow to toggle through the available LED colors.
• The available LED colors include red, green, blue, and
magenta.
4. Touch the to return to the Select Lockers screen.
Form No. F2GM-0820
Updating the Touchscreen Controller
Software
for system settings.
1. Move the Power I/O (on/off) switch to the I (on) position.
2. Insert a USB drive with the latest software into the USB slot.
3. After the two loading screens finish the software
or arrow
NOTE: Wait at least one minute before turning power off to the
4. Restart the unit.
5. Verify that the software was updated.
for system settings.
or
15
• The software folder must be in the root folder on the
USB drive.
• The software will update automatically when the USB
drive is inserted.
USB Slot
Touchscreen Controller
USB Slot
installation, wait at least 10 seconds and then remove the
USB drive.
• The USB drive must be removed while the unit is still on
or the update will not apply to the software.
unit after updating the software.
a. Move the Power I/O switch to the O (off) position.
b. Move the Power I/O switch to the I (on) position.
• The customer-side controller displays the HMI version
on the startup screen.
• The operator-side controller displays the HMI version
by selecting the "System Info" on the System Settings
Screen.
OPERATION