Fitting Instructions - R&G CP0432BL Instructions

Picture 33

FITTING INSTRUCTIONS


To remove the left side fairing on the bike, remove the six bolts that are arrowed in picture 1.

Remove the bolt that secures the rear of the infill panel, as arrowed in picture 2.

Remove the push rivet on the front corner of the infill panel behind the headlights, as arrowed
in picture 3.

The infill panel can now be removed, as shown in picture 4. Repeat the above three stages to
remove the fairing bolts and infill panel on the right side of the bike.

Remove the four push rivets that secure the radiator cowl in place on the left side of the bike,
as shown in pictures 5, 6 & 7, before removing the cowl from the bike. Repeat this procedure
to remove the right side radiator cowl.

Remove the mirrors from the bike by disconnecting the wiring connector for the indicators
and then removing the two nuts that secure the indicator in place, as shown in picture 8.

Remove the mirror whilst feeding the connector and wiring out from the hole, as shown in
picture 9. Repeat for the other side.

On the right side of the bike, remove the bolt that is arrowed in picture 10.

Remove the three bolts that secure the right side headlight unit in place, as arrowed in pictures
11, 12 & 13.

Disconnect the two large white wiring connectors, as shown in pictures 14 & 15.

The right side headlight unit can now be removed from the bike, as shown in picture 16.

Repeat the above four stages to remove the left side headlight unit, as shown in picture 17
(there is only one large white connector to disconnect).

The front fairing can now be removed (this is a little tricky and may require a second person).
The fairing is held on by four yellow plastic clip mounts, as shown in pictures 18, 19 & 20.
These need to be squeezed together whilst the fairing is gently pulled in order to release from
their mounts. The best way to do this is by using long nose pliers or a screwdriver to squeeze
the clip from inside the fairing, whilst an assistant gently pulls the fairing from the front in the
immediate area around each clip.

Once removed, access can be gain to the final two fairing bolts. Remove these, as shown on
the right side in picture 21.

The fairings can now be removed, by unclipping towards the front, releasing the yellow clip
that is shown in picture 22 and removing from the bike, as shown in picture 23.

Remove the fairing on the right side of the bike as well.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com
CP0432
Picture 34
Email: info@rg-racing.com