Information Menu; Mowing Tips; Battery; Transport - Solo evoCUT 4.0 Instructions D'emploi

SETTING MENU, INFORMATION MENU, MOWING TIPS, BATTERY, TRANSPORT
Confirm the selection with the [menu key] and
return to the main menu.

12. INFORMATION MENU

The information menu is used for calling up the
software status, hardware status, current settings
(program info) and faults. No settings can be
made in this menu.
Faults
Display of date, time and fault code with fault
message. All fault messages since start-up are
listed.

13. MOWING TIPS

Cutting height at a constant 3 - 6 cm, do not
mow off more than half of the lawn height.
Adjust the mowing times accordingly.
If the motor speed drops noticeably because of
thick grass, increase the cutting height and
mow in several passes.
To allow the performance of the evoCUT
4.0 to be exploited to the full, we
recommend having the automatic
lawnmower mow the lawn during cool times of the
day.
DANGER!
Danger of injury due to the cutting blades!
Before all maintenance and care jobs, always
switch off the automatic lawnmower using the
[ON/OFF key].
Disconnect the transformer of the base station
from the mains.
Always wear work gloves when performing
maintenance and care jobs on rotating and/or
cutting tools!
ENGLISH 12

14. BATTERY

The integrated battery is partially charged on
delivery. During normal operation, the battery of
the evoCUT 4.0 is regularly recharged.
When the battery charge reaches 0%, the
evoCUT 4.0 automatically returns to its base
station in order to charge the battery.
Interrupting charging does not damage the
battery.
The base station is equipped with an electronic
control unit with a monitoring function. This
automatically terminates the charging procedure
when a 100% charge status is reached.
The battery status is shown on the display.
Make sure the charging contacts (Fig. 7 - 1) of
the base station have adequate contact with the
contact surfaces (Fig. 7 - 2) on the evoCUT 4.0.
The temperature range for charging should be
between 0 and 40 °C.
The built in protection circuit prevents the
battery from being charged at temperatures
above 45 °C, in order to prevent irreparable
damage to the battery.
If the operating time of the battery is reduced in
spite of it being fully charged, have the battery
replaced by a new genuine battery. This task
should be carried out by a SOLO dealer,
technician or service partner.
If the battery charge level has dropped below
the threshold set by the manufacturer as a
result of ageing or excessively long storage, this
means it cannot be recharged any longer. Have
the battery and the monitoring electronic control
unit checked by a SOLO dealer, technician or
service partner, and renew it if necessary.
The battery status is shown on the display.
Check the battery status after about 3 months
by switching on the evoCUT 4.0 and reading off
the battery status. If necessary, place it in the
base station for charging.

15. TRANSPORT

Only carry the evoCUT 4.0 by its deck.
Stop the evoCUT 4.0 using the [STOP key]
(Fig. 3 - 2).
Switch off the evoCUT 4.0 using the [ON/OFF
key] (Fig. 3 - 7).
DANGER!
Danger of injury due to the cutting blades!
During transport, always keep the cutting
blade plate facing away from your body.