Overview Of Main Menu - Solo evoCUT 4.0 Instructions D'emploi

Calibration procedure
The evoCUT 4.0 first moves straight over the
boundary cable in order to gauge the signal
strength, and then into the base station. The
battery of the evoCUT 4.0 is charged.
The evoCUT 4.0 must remain stopped
when it moves into the base station. If the
evoCUT 4.0 does not meet the contacts
when it moves into the base station, it will move
further along the boundary cable until it meets the
contacts or the procedure is cancelled.
The following menu items can be selected:
Mainmenu
Press menu key [Fig. 3 - 8] to open the main menu..
Select the required program item with the [arrow keys] (Fig. 3 - 3) and confirm with the [multifunction
key right] (Fig. 3 - 5).
Each menu can be exited using the menu keys [Fig. 3 - 8].

9. OVERVIEW OF MAIN MENU

Programs
Settings
Information
START-UP, OVERVIEW OF MAIN MENU
Display after the calibration movement
The mowing window preset at the factory is
displayed after calibration.
The mowing program is active, the battery is
charged.
After calibration has been completed, the evoCUT
4.0 can be used for mowing with the factory-set
mowing times without further programming.
The following mowing times are factory-set:
Mon - Fri: 07:00 - 10:00 and Mon - Fri: 17:00 -
19:00.
Observe local ordinances regarding operating
times.
Week program
Entry points
Program info
Time
Date
Language
Setting the cutting height
PIN code
Button tones
Rain sensor
Edge mowing
Display contrast
Recalibrate
Factory settings
Hardware
Software
Program info
Faults
ENGLISH 9