Fault Code - Solo evoCUT 4.0 Instructions D'emploi

18.2

Fault code

Error message
CN001:
Tilt sensor
CN002:
Lift sensor
CN005:
Bumper deflected
CN007:
No loop signal
CN017:
Cal: signal weak
CN008:
Loop signal weak
CN010:
Bad position
CN011:
Escaped robot
CN012:
Cal: no loop
CN015:
Cal: outside
CN018:
Cal: Collision
CN038:
Battery
Possible cause
Max. tilt exceeded
Automatic lawnmower has been
carried
Slope too steep
Cover has been deflected upwards
by lifting or by a foreign body.
Automatic lawnmower has
encountered an obstacle and cannot
free itself (collision close to base
station).
No loop signal. Fault during
calibration, loop signal too weak.
Loop signal weak.
Automatic lawnmower is outside loop.
Automatic lawnmower has left field.
Fault during calibration, automatic
lawnmower could not find loop.
Fault during calibration, collision
Battery flat.
Boundary cable defective, automatic
lawnmower does not find base
station.
Battery exhausted.
Charging electronics faulty.
Automatic lawnmower does not touch
charging contacts.
TROUBLESHOOTING
Solution
Place automatic lawnmower on a flat
surface and acknowledge fault.
Remove foreign body.
Check base station power supply
Check loop
Disconnect and reconnect transformer
Check base station power supply
Check loop, it has possibly been buried
too deep
Disconnect and reconnect transformer
Place automatic lawnmower in mowing
area
Loop crossed-over
Check routing of loop (curves, obstacles,
etc.)
Place automatic lawnmower at right
angles to loop, automatic lawnmower
must be able to drive over loop
Check base station power supply
Check loop
Disconnect and reconnect transformer
Loop cable crossed-over
Remove obstacle
Check base station for obstacles
Check base station charging contacts
Loop too long, too many islands
Automatic lawnmower has got stuck
Check boundary cable for interruptions, if
necessary have it tested by a SOLO
service partner.
Battery service life exceeded. Have
battery renewed by a SOLO service
partner.
Have charging electronics renewed by a
SOLO service partner.
Put automatic lawnmower into base
stationand check if charging contacts
make contact
Have charging contacts checked and
renewed by a SOLO service partner
ENGLISH 15