Setting Menu; Information Menu; Mowing Tips; Setting The Cutting Height - Solo Robolinho 1000 Traduction Du Mode D'emploi D'origine

en
3. Use the [up arrow key] or the [down arrow key]
to select the [Point X*] menu item until the star
symbol appears to the left of the menu item.
4. Set the required distances and set additional
entry points if necessary.
5. Confirm with the [multifunction key right].
6. Press the [menu key] again to return to the
main menu.
By default, the first entry point is al-
ways 1 m to the right of the base sta-
tion, and cannot be changed.
By default, another 9 entry points
are distributed along the overall
length of the boundary cable (after
the 1st edge mowing or complete
loop movement).
These entry points can be changed
and programmed according to the
size and composition of the mowing
area.
Learning entry points
(Robolinho 1000)
1. Press the [START/PAUSE key] to start the
procedure.
Follow the instructions on the display.
[Learn entry points]
2. Set entry point X.
3. Position: Set Y with the [multifunction key
right].
No entry point is set.
The loop length is measured and the
start points are automatically distri-
buted evenly over the length.
The entry points can be adapted
manually.

SETTING MENU

Set the data, time, language and recalibrate, see
start-up.
Activate or deactivate the button tones
1. Select [button tones].
2. Confirm with the [multifunction key right] (3-5).
3. Activate or deactivate the button tones with
the [multifunction key right] (3-5).
4. Confirm the corresponding selection with the
[menu key] (3-8).
34
Changing the display contrast
1 Select [Display contrast].
2 Select [Display contrast] with the [arrow keys]
(3-3) and confirm with the [multifunction key
right] (3-5).
3 Confirm the selection with the [menu key]
(3-8) and return to the main menu.
Restoring factory settings
1 Select [Factory settings].
2 Enter the PIN code again and confirm.
3 Confirm the selection with the [menu key]
(3-8) and return to the main menu.

INFORMATION MENU

The information menu is used for calling up the
software status, hardware status, current settings
(program info) and faults. No settings can be
made in this menu.
Faults
Display of date, time and fault code with fault mes-
sage. All fault messages since start-up are listed.

MOWING TIPS

Cutting height at a constant 3 - 6 cm, do not
mow off more than half of the lawn height.
Adjust the mowing times accordingly.
If the motor speed drops noticeably because
of thick grass, increase the cutting height and
mow in several passes.
To allow the performance of the
Robolinho to be exploited to the full, we
recommend having the automatic lawn-
mower mow the lawn during cool times
of the day or at night.
DANGER!
Danger of injury due to the cutting bla-
des!
Before all maintenance and care
jobs, always switch off the automatic
lawnmower using the [ON/OFF key].
Disconnect the transformer of the
base station from the mains.
Always wear work gloves when per-
forming maintenance and care jobs
on rotating and/or cutting tools!

SETTING THE CUTTING HEIGHT

Opening the cover
Setting entry points
Robolinho 1000/100
®