Table des Matières
Publicité
section. If these bolts bent during shipping and consequently refuse to enter the
holes, then feel free to straighten them out. For this, you can use a tube or a hollow
wrench into which you will capture the bolt's end and straighten them out until their
ends match the holes. Then, mount the seat on the front section of the frame using
the two zips. The first time, you may find it difficult because the seat is brand new,
however even if the seat seems too tight, it will self-adjust to the frame later (Figure
5).
Figure 3
Figure 5
Figure 4
4
Publicité
Table des Matières
