Perform Function Inspection Of Throttle/Brake - Reely Generation X Notice D'emploi

d) Perform Function Inspection of Throttle/Brake
The positioning of the adjustment rings (the mechanical limit stops) of the stop springs on the throttle linkage and the
brake linkage have been set in the factory. They are attuned to the mechanical stops of the carburettor and the disc
brakes. The throttle/brake linkage shouldn't require readjustment.
However, brake pads may wear and set collars may become loose after extended operation and must be retightened.
If the brake is set incorrectly and drags, the brake pads wear off as well as the brake disc!
The throttle/brake linkages have the following impact:
Full throttle (A): The carburettor slider is fully extended, the brake has no effect.
Idle (B): The carburettor slide is deflected all the way (air gap for idle), the set collars at the brake levers are
loosely aligned; the brake is ready for function but not effective yet.
Brakes (C): The throttle linkage pushes against the spring resistance; the brake linkage pushes the brake shoes
against the brake discs.
A B
Figure 5
C
Figure 6
59