Migatronic AUTOMIG2 183i Manuel D'instruction page 17

Important: stretch out welding hose, earth cable and
interconnecting cable, as necessary, as shown in the figure
to avoid affecting the welding performance and at worst
destructing the welding machine.
Lift instructions
Lifting hooks can be used at the sack barrow for lifting with
a crane (figure 1).
The trolley with four wheels cannot be lifted with a crane but
only manually using the handle (figure 2).
The machine must not be lifted with mounted gas bottle!
All manuals and user guides at all-guides.com
17
Connection of shielding gas
The shielding gas hose is fitted to the back panel
of the power source (3) and is connected to a
gas supply with a pressure reduction to max.
6 bar. One gas cylinder can be mounted on the
bottle carrier on the back of a trolley if any.
Note: Use only gas bottles with a max. weight of
2
20 kg for AUTOMIG 183i. If larger bottles are
used the machine may tip over.
Connection of torch for MIG/MAG welding
The welding hose assembly is pushed into the
central connector coupling (4) and the nut (5) is
tightened by hand. The return lead is connected
to the negative pole (6).
Connection of torch 1 (7) and torch 2 (8) for
MIG/MAG-welding AUTOMIG
Push the welding hose assembly into the central
connector coupling (7 and 8) and tighten the nut
(5)
by hand. Use the reverser (9) to switch between
welding torches 1 and 2 and motor and gas
valves 1 and 2.
Connect the return lead to the negative pole
(10).
Torch adjustment (Dialog torch)
The current size can be adjusted both from the
machine and the welding torch if a welding hose
with dialog torch is in use. The torch adjustment
is passive without Dialog torch.
2
Inching AUTOMIG 183i
The function is
used for wire
inching e.g.
after change of
wire. Wire
inching starts
by pressing the
green key pad
and simultaneously triggering the torch trigger.
Wire inching continues even though the green
key pad has been released. It does not stop until
the torch trigger has been released again.
Inching
2
AUTOMIG 223i/273i
The function is used for wire
inching e.g. after change of
wire.
2
i DUO