Power Source - Migatronic AUTOMIG2 183i Manuel D'instruction

Error codes for Power control package 10001641.cry
Error code Cause and solution
The file 10001641.cry has an error.
1. Insert the SD card in the machine again.
2. Exchange the SD card.
SD card is not formatted.

The SD card must be formatted in a PC
as FAT. Or use another SD card.
The software does not match this control
unit.

Use a SD card with software that
matches your control unit.
Power control PCB is defective

Contact MIGATRONIC Service
Data transmission error

Turn on and off the machine. Exchange
the SD card if the error is displayed
again. Contact your dealer if necessary.
The file 10001641.cry has an error.
1. Insert the SD card in the machine again.
2. Exchange the SD card.
Power control PCB is defective

Contact MIGATRONIC Service
The SD card contains too many files with
10001641.cry-data
All manuals and user guides at all-guides.com
23
MAINTENANCE
The machine requires periodical maintenance and
cleaning in order to avoid malfunction and cancellation
of the guarantee.
WARNING !
Only trained and qualified staff members can carry
out maintenance and cleaning. The machine must
be disconnected from the mains supply (pull out
the mains plug!). Thereafter, wait around
5 minutes before maintenance and repairing, as all
capacitors need to be discharged due to risk of
shock.
Wire cabinet
- Regularly, clean the wire cabinet with compressed
air and check if the grooves and teeth on the wire
drive rolls are worn out.

Power source

Clean the fan blades and the components in the
-
cooling pipe with clean, dry, compressed air as
required.
A trained and qualified staff member must carry out
-
inspection and cleaning at least once a year.