Product Programme; Connection And Operation - Migatronic AUTOMIG2 183i Manuel D'instruction

PRODUCT PROGRAMME

180/220/270A welding machine for MIG/MAG welding.
The machine is air-cooled and is supplied with built-in
wire feed with 4-roll drive.
Welding hoses and cables
MIGATRONIC's product range can provide MIG/MAG
torches and hoses, return current cables, intermediary
cables and wear parts etc.
Accessories
Please contact your Migatronic dealer for further
information on accessories.
Dispose of the product according to local
standards and regulations.
www.migatronic.com/goto/weee

CONNECTION AND OPERATION

Permissible installation
The following sections describe how the machine is
made ready for use and then connected to mains
supply, gas supply etc. The numbers in parentheses
refer to the illustrations in this paragraph.
2
Unpacking the AUTOMIG
After unpacking and prior to using the
2
AUTOMIG 223i/273i, proceed as follows (see
drawing):
2
Please note: AUTOMIG 183i has a permanently fixed
trolley.
All manuals and user guides at all-guides.com
223i/273i
Mains connection
Before connecting the power source to the mains
supply, ensure that the power source is of the same
voltage as the mains voltage provided and that the
fuse in the mains supply is of the correct size. The
mains cable (1) of the power source must be
connected to the correct three-phase alternating
current (AC) supply of 50 Hz or 60 Hz and with earth
connection. The sequence of the phases is not of
significance. The power source is switched on with the
mains switch (2).
Mains connection AUTOMIG
2
Please note: AUTOMIG 183i is not available in
Boost version
2
The AUTOMIG Boost can be connected to single-
phase and three-phase mains supply from 200 to
440V. The machine automatically adjusts itself to the
present mains voltage.
The mains plug must be mounted by an electrician.
The machine is equipped with a four-wire mains cable
and must be mounted as shown below:
Configuration
MIGATRONIC disclaims all responsibility for damaged
cables and other damages related to welding with
undersized welding torch and welding cables
measured by welding specifications e.g. in relation to
permissible load.
Generator use
This welding machine can be used at all mains
supplies providing sine-shaped current and voltage
and not exceeding the approved voltage tolerances
stated in the technical data. Motorised generators
observing the above can be used as mains supply.
Consult your supplier of generator prior to connecting
your welding machine. MIGATRONIC recommends
use of a generator with electronic regulator and supply
of minimum 1.5 x the maximum kVA consumption of
the welding machine. The guarantee does not cover
damage caused by incorrect or poor mains supply.
Important!
In order to avoid damage to plugs
and cables, good electric contact is
required when connecting the work
return cable and welding torch to
the machine.
16
2
Boost