Reset; Reset Procedure - Chauvin Arnoux MPC 350 Notice De Fonctionnement

English
The numerical display indicates the present setting.
Press the
To adjust the numerical display to the desired 100/100 value.
Press the
The MPC 350 then returns to the pH measurement mode.
The adjustment procedure is the same for the other parameters.
ATTENTION: IN CONDUCTIVITY, THE RECORDER OUTPUT (0V) IS
INOPERATIVE IF THE MPC 350 IS IN THE "automatic range switching"
MODE.

6.4 RESET

Following a power outage or a magnetic or RF perturbation, the memories may
contain incorrect values.
The MPC 350 must then be reset to operate normally.
6.4.1

RESET PROCEDURE:

Press the
The alphanumeric display indicates:
70
or
key to validate
key.
key
VAL ****
MPC 350 Multiparameter meter