Or manual temperature
The
3.2 TEMPERATURE ADJUSTMENT AND MEASUREMENT
The temperature probe (platinum resistance, 100Ω at 0°C) is connected to the
lockable 5-pin plug.
It is used to measure the temperature.
It compensates for the variation of electrode response in pH measurements.
It corrects the conductivity (the conductivity values are referred to 25°C)
For accurate measurements, it is therefore essential to calibrate this parameter
first.
On the MPC 350, the temperature correction can be applied manually or
automatically.
MPC 350 Multiparameter meter
key is used to display the various parameters one by one.
000
** mV **
1000 Micro/cm
25.0 ** TC **
** TC MAN **
English
49