Press the:
To set to the desired value
Then on the
The instrument then changes back to
the temperature measurement mode.
Note: maximum offset: ± 3°C
Beyond this offset, the alphanumeric display indicates:
3.2.3
MANUAL CORRECTION
This function can be used if the temperature probe is not connected.
For the adjustment, the temperature of the product to be measured must be
displayed.
The factory setting of this parameter is 25.0.
Example: solution or standard at 20.0°C:
Press the
The instrument switches to manual
temperature adjustment mode
MPC 350 Multiparameter meter
key to validate.
key
or
20.0 6 – 7 et 8
20.0 ** TC **
REFUSE
25.0 *TC MAN*
25.0 REG MAN
6 – 7 et 8
English
rejected
51