Use; Connection And Starting Up; Selection Of The Parameter(S) Displayed - Chauvin Arnoux MPC 350 Notice De Fonctionnement

English

3. USE

3.1 CONNECTION AND STARTING UP

Unpack the instrument, the power supply unit, the calibration solutions, the
operating manual, and the short-circuit plug.
Connect the various probes used.
If one of the parameters, pH or mV, is not used, connect the short-circuit plug
instead of the corresponding electrode.
The display will then be locked at 7.00 (pH) or 000 (mV).
Connect the power supply unit to the "power supply" connector.
(The MPC 350 must be used with the power supply unit provided).
Press the On/Off key:
The alphanumeric display indicates the last parameter(s) measured.
The display unit indicates measurement of this parameter.
Press the On/Off key: to switch off the instrument.
3.1.1

SELECTION OF THE PARAMETER(S) DISPLAYED

Press the key corresponding to the desired parameter:
7.00 ** pH **
48 MPC 350 Multiparameter meter