Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
8
9
SET/TEST
Allows the user to test the detection system of the camera.
When the "SET/TEST" mode is selected, no picture or video
is recorded. Walk perpendicularly in front of the camera. When
the camera detects movement, the light blinks to indicate
that normally, a photo or video would be recorded. If the
system does not detect the movement, increase the distance
detection using the wheel "DISTANCE" or realign the system
differently. When you understand how the device responds to
detections, you can better adjust the direction or the height of
the installation.
How to properly install your camera
using the supplied installation strap:
(Recommanded installation height: about 3 feet).
Test Light
VIEW
Allows the user to view photos and videos directly on a TV set.
Turn "OFF" your camera and select "VIEW". Connect the
yellow end of the audio-video cable (supplied) into the
"VIDEO IN" of the TV and the other end into the "TV OUT" of
the camera. Turn "ON" the camera. You will see the last picture
or video recorded by your system. To change the picture or the
video, use the key "UP" or "DOWN". If you press "MENU/
OK", the following options will appear:
Publicité
Table des Matières
