Crease adapter
With this adapter, you can iron creases (e.g. into trousers and skirts).
Adding/removing water
AttEntIon!
❐ Before adding water to/emptying the water tank, always disconnect the mains plug. In the
process, never pull on the cord, but always on the plug.
❐ Allow the device to cool off completely before adding more water. Otherwise an uncon-
trolled emission of steam could occur.
❐ Never fill more than the maximum level shown on the measuring cup (max. 100 ml). Use
distilled water to fill the device.
❐ Never fill the device with cleaners or other additives. They may irreparably damage the
device and as such, the safe operation of the unit can no longer be assured.
1. Fill the measuring cup with water (no more than 100 ml).
2. Open the water tank by pulling the water tank cap out of the device. Please note that the
cap cannot be completely removed from the device.
3. Fill the water tank with water using the measuring cup.
4. Close the water tank by firmly pushing the cap into the opening of the tank. Make sure that
the water tank is completely closed.
5. To empty the water tank, open the water tank cap and turn the device upside down. This
allows any remaining water to drain from the tank.
use
AttEntIon!
❐ Never point the steam directly at people, pets or plants. This can lead to serious scalds.
❐ Never attempt to iron clothing when being worn by someone.
❐ Only hold the device by the handle during operation. There is a scalding hazard!
❐ Always work with sufficient lighting.
❐ Never use the device without water.
03397_DE-GB-FR-NL_V1.indb 16
All manuals and user guides at all-guides.com
1. To mount the crease adapter, place it on the heat plate
in a level position as shown and push the catches on the
adapter into the corresponding openings on the device.
The adapter must audibly lock into place.
2. To remove the crease adapter, push the release button
on the adapter, hold it firmly and pull the adapter off of
the device.
16
06.08.10 14:21