Filling The Water Reservoir - Cleanmaxx HS101 Mode D'emploi

EN
Curved Attachment
Combination attachment
The combination attachment (3) is used in conjunction with the cleaning cloth.
• Plug the combination attachment as far as it will go onto the steam nozzle (13) of the
device and screw it on tight.
Cleaning Cloth
The cleaning cloth is suitable for cleaning and refreshing upholstery and textiles and
also for scratch-sensitive and fairly large surfaces, e.g. shower cubicles.
• Pull the cleaning cloth over the combination attachment (3). Allow the cleaning
cloth to cool down after use before you detach it!

Filling the Water Reservoir

CAUTION!
■ Always pull out the mains plug and allow the device to cool down completely before
you open the water reservoir. Otherwise there could be an uncontrolled emission of
steam.
■ Do not overfi ll the water reservoir. Pour a maximum of 260 ml of water into the de-
vice.
■ Never hold the device under the tap and never immerse it in water to pour water into
the reservoir.
■ Never pour any cleaning agent or other additives into the device. This could destroy
the device and safe working is no longer guaranteed.
1. The device has a safety reservoir cap (6). It cannot be removed if the water reservoir
is pressurised. Press the reservoir cap down and unscrew it in the anticlockwise
direction.
To release pressure from the water reservoir, keep pressing the steam trigger (9)
until steam stops emerging from the device. The water reservoir can then be
opened.
2. Pour water into the water reservoir using the measuring cup and the funnel supplied.
3. Screw the reservoir cap back into the device.
18
Use the curved attachment (4) for cleaning places or crevices
which are hard to reach.
• Plug it directly onto the steam nozzle (13) of the device or
the long nozzle attachment (2).