Mounting / Removing Attachments; Filling The Water Reservoir - Cleanmaxx YF-418-12 Mode D'emploi

Mounting / Removing Attachments

NOTE!
■ Shortly after use, the attachment used may still be very hot. Wait until the device and
the attachment used have cooled down completely before removing them.

Filling the Water Reservoir

NOTE!
■ After use, the device may still be hot. Wait until the water reservoir has cooled com-
pletely before fi lling / emptying it.
■ Never pour any cleaning agent or other additives into the device. This may destroy
the device and safe working is no longer guaranteed.
■ Pour no more than 250 ml (note the max marking) of water into the water reservoir.
The device can be operated with both tap water and distilled water. However, if
you use tap water, the device will need to be regularly descaled (see the "Clean-
ing and Storage" chapter, "Descaling" section). If you use distilled water, there is
no need to descale the device.
1. Fill the measuring cup up to the MAX marking with water.
2. Pull the water reservoir cap (4) out of the water reservoir (5) Please note that it can-
not be completely detached from the device.
3. Pour the water from the measuring cup into the water reservoir. Here too you should
only pour up to the max marking.
4. Close the water reservoir cap again. Make sure that the water reservoir is properly
closed.
17
• Attaching: Place the attachment with the locking lug at
the top on the steam bottom and press it down fi rmly. The
attachment must be heard to engage in place.
• Removing: Pull the tab on the bottom of the attachment
forwards and remove the attachment.
EN