Installation Instructions - Kübler Ants LEB02 Instructions D'utilisation

Kübler Group
NOTICE

4.1.5 Installation instructions

ATTENTION
ATTENTION
NOTICE
BA Ants LEB02 - R60074.0009 - 02
Coded band orientation and condition
Ensure proper coded band orientation. This is important for the good
operation of the sensor.
• Important: Also pay imperatively attention to the side orientation of
the holes. A marking showing the proper orientation can be found
on the type plate of the sensor.
• Do not remove the type plate at the beginning of the coded band,
which shows the "top end" for the installation orientation of the
coded band.
Coded bands without such label may not be used.
• Make sure during elevator downwards travel that there is no dirt or
foreign bodies on the coded band.
Do not bend or twist the coded band
During the first travel after installing the coded band, make sure that
the sensor is mounted so that it can move, to allow the pretensioned
coded band to align it as far as possible itself in an optimal position
with respect to the coded band. A deflection of the coded band due to
the sensor is not allowed.
This adjustment must result in a straight, pressure-free, smooth
movement of the coded band through the two slides, without twisting
the coded band.
Do not bend or lever the locking element
Only loosen the fastening screw of the locking element enough to be
able to slide the element and pull out the external slide (up to 5
threads).
Do not try to bend the locking element or use a lever to take it out of
the screwed connection.
The perfect fastening of the two slides guarantees the exact guiding
of the coded band. Otherwise, shorter maintenance cycles or even
malfunctions must be reckoned with.
Sensor position
Take care to the proper position, which depends on the already
mounted coded band and is determined by the three mounting pos-
sibilities in respective 90° steps.
To perform the adjustment of the sensor, do not tighten the sensor
car fastening screw, nor the screws holding the fastening plate on the
car roof.
4 Installation
EN - 35