Servicing Filter And Spark Guard - Miller FILTAIR MWX-D Manuel D'utilisation

7-3. Servicing Filter And Spark Guard

7-3. Servicing Filter And Spark Guard
4
rubbergloves weldgloves
rubbergloves weldgloves
glasses
oilcan filtersocket
glasses
snapringpliers
oilcan
pinextractor2
OM-239025 Page 22
snapringpliers
1
earmuffs ear plugs
805269-B
earmuffs
hairdryer cclamp
hacksaw
hairdryer
linepliers pencil
filtersocket
tip_dress
linepliers pencil
2
3
tools/
electrodewrench
tools/
ear plugs electrodewrench
rpmmeter
belttensiongauge
cclamp rpmmeter
fusepuller
hacksaw belttensiongauge
sealant_2
fusepuller
! Turn off unit and disconnect in-
put power cord.
! Do not operate unit without fil-
ter or with dirty (plugged) filter.
! Allow cooling period before in-
specting or replacing filter, or
cleaning spark guard.
! Replace the filter when dirty. Do
Turn off power and disconnect in-
not clean the filter or use a filter
put power cord.
that has been cleaned.
Do not operate unit without filter or
! Do not breathe the particles col-
with dirty (plugged) filter.
lected by the fume extractor.
Allow cooling period before in-
Wear approved safety equip-
specting or replacing filter, or
ment (respirator, gloves, long
cleaning spark guard.
sleeve shirt) when servicing fil-
ter and spark guard. Dispose of
Replace the filter when dirty. Do
used element and collected par-
not clean the filter or use a filter
ticles according to local, state,
that has been cleaned.
and federal requirements.
Do not breathe the particles col-
! Read and understand the Mate-
lected by the fume extractor. Wear
rial Safety Data Sheets (S DSs)
approved safety equipment (respi-
and the manufacturer's instruc-
rator, gloves, long sleeve shirt)
tions for metals, consumables,
when servicing filter and spark
coatings, cleaners, and de-
guard. Dispose of used element
greasers.
and collected particles according
1 Latch
to local, state,
requirements.
2 Hatch
Read and understand the Safety
3 Filter
Data Sheets (SDSs) and the manu-
4 Spark Guard
facturer's instructions for metals,
Release latches and open hatch. Use
consumables, coatings, cleaners,
filter handles to remove filter.
and degreasers.
1 Latch
Replace filter if dirty or damaged.
2 Hatch
Wipe off hatch. Vacuum particles from
inside of housing.
3 Filter
4 Spark Guard
Remove spark guard (from behind
baffle).
Release latches and open hatch. Use filter
helmet weldshield
Clean and inspect spark guard screen.
handles to remove filter.
Replace spark guard if screen wires
are broken or missing.
Replace filter if dirty or damaged.
Install spark guard.
Wipe off hatch. Vacuum particles from inside
Install filter.
of housing.
Close hatch and secure with latches.
Remove spark guard (from behind baffle).
Clean and inspect spark guard screen. Re-
place spark guard if screen wires are broken
or missing.
helmet weldshield
benchvise Install spark guard.
popriveter
Install filter.
Tools Needed:
Close hatch and secure with latches.
sealant_1
benchvise
popriveter
mallet scissors
OM-239025 Page 19
sealant_1
pump pliers
mallet
and federal
faceshield
faceshield
tape
tape
Torx
scissors