Videotec MAXIMUS MHX Manuel D'instructions page 35

8 Maintenance
Before carrying out any type of
intervention, read the "Safety rules"
chapter of this manual.
8.1 Routine maintenance
When contacting VIDEOTEC for assistance please
provide the serial number and the identification
code of the model.
Use only VIDEOTEC original spare parts.
8.1.1 Inspecting the cables
The cables should not show signs of damage or
wear, which could generate hazardous situations.
In cases of damaged or worn cables, repair or
replacement will be required.
8.1.2 Replacing the gasket
After each opening of the product replace the
O-ring gasket before closing the product. Use only
VIDEOTEC original spare parts.
Open and close the rear flange of the product as
described in the chapters above.
Replace O-ring gasket paying attention to position
it correctly.
Fig. 47
MNVCMHX_2222_EN
8.2 Extraordinary maintenance
8.2.1 Fuses replacement
CAUTION! To ensure protection against the
risk of fire, replace the fuse with one the
same type and value. The fuse must only
be replaced by qualified staff.
If necessary, the connector board's fuse can be
replaced. The new fuse must comply with the
directions given in the table.
FUSES REPLACEMENT
Supply voltage
12Vdc
24Vac, 50/60Hz
120Vac, 50/60Hz
230Vac, 50/60Hz
Tab. 14
FUS1
Fig. 48 MHX without wiper.
Fig. 49 MHX with wiper and MHXT.
Fuse (FUS1)
T 4A H 250V 5x20
T 4A H 250V 5x20
T 1A L 250V 5x20
T 1A L 250V 5x20
FUS1
33