Videotec MAXIMUS MHX Manuel D'instructions page 28

6.12 Optical fiber connection
Use a type of optical fiber suitable for the
receiver model installed.
Video and data transmission can be made via optical
fiber.
Connect the camera's video output to the CPU
board's J10 connector. Use the appropriate BNC-BNC
cable supplied.
J10
Fig. 32
For Multi Mode fibre transmitters use fibre
62.5/125μm with a maximum length of 3km (1.9mi).
26
For Single Mode fibre transmitters use fibre 9/125μm
with a maximum length of 69km (42.9mi).
Slide the fiber through the entry device.
Connect optical fiber with ST type connector.
Connect the optical fibre to the transceiver board by
paying attention to the bending radius.
For further details please refer to the
manual of the optical fibre receiver.
Fig. 33
MNVCMHX_2222_EN