Videotec MAXIMUS MHX Manuel D'instructions page 17

Fasten the housing at the junction with the screws
and washers provided.
Fig. 4
Apply a generous amount of thread locking
compound (Loctite 270).
Tighten the screws.
Pay attention to the fixing. Tightening
torque: From 9Nm a 12Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
MNVCMHX_2222_EN
6.1.2 Bracket mounting
The bracket can be fixed to the vertical wall. Use
screws and wall fixing devices that can bear at least
four times the weight of the unit.
Fig. 5
Then, fix the device to the bracket using the 4 flat
washers, the 4 spring washers in stainless steel and
the 4 hexagonal head screws in stainless steel (A4
class 70) supplied (M10x20mm).
Make sure the thread are free of dirt and debris.
Apply a generous amount of thread locking
compound (Loctite 270) on the 4 screws.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: From 9Nm a 12Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
15