Videotec MAXIMUS MHX Manuel D'instructions page 27

6.10.3 Connection of the camera power
supply in 24Vac, 120Vac, 230Vac and
12Vdc for MHX with wiper and for
MHXT
Remove the removable terminal from the board.
Carry out the wiring between the removable
terminal and the camera's power supply terminals.
Re-insert the terminal into the connector.
CONNECTION OF THE CAMERA TO THE POWER SUPPLY
Camera power supply
voltage
Connector board
230Vac
120Vac
24Vac
CPU board
12Vdc
Tab. 9
Fig. 30
MNVCMHX_2222_EN
Housing power voltage
12Vdc 24Vac 120Vac 230Vac
– – –
– – J6
– J7 J7
J13 J13 J13
J13
J6 J7
6.11 Camera with analogue video
output
CDS installation type (Cable Distribution
System). The installation is type TNV-1, do
not connect it to SELV circuits.
The video signal coming from an analogue camera
can be transmitted via a coaxial cable or optical fibre.
Suggested coaxial cables are:
• RG59
• RG174A/U UL1354
Slide the coaxial cable through the entry device.
Connect the coaxial cable to the camera's BNC video
J6
connector. Use a 75Ohm BNC male connector (not
–
supplied).
J7
J13
Fig. 31
25