Videotec MAXIMUS MHX Manuel D'instructions page 19

6.2 Sunshield mounting
You can fix the sunshield to the housing using the
screws supplied.
Apply a generous amount of thread locking
compound (Loctite 270) into the threaded holes in
the base of the device.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 8
6.3 Fastening of the wiper blade
Insert the blade on the wiper shaft.
Fasten the wiper brush by means of the flat washer,
the toothed washer and the nut.
Fig. 9
MNVCMHX_2222_EN
6.4 Adjusting the protection grid
The protection grid may be adjusted moving it
upwards, to fit it with the field of view of certain
cameras.
The protective grate must always be
present when the product is running.
Fig. 10
17