Videotec MAXIMUS MHX Manuel D'instructions page 16

5 Preparing the product for
use
Before carrying out any type of
intervention, read the "Safety rules"
chapter of this manual.
5.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Flameproof housing
• Sunshield
• Wiring for motherboards connection
• Silicone sheath
• Cable tie
• Spacer and screws for mounting the sunshield
• Plastic spacers and screws ¼" for camera and lens
mounting
• O-ring replacement part kit
• Extraction screws
• Wiper brush (version with wiper)
• Instruction manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
14
6 Installation
Before carrying out any type of
intervention, read the "Safety rules"
chapter of this manual.
VIDEOTEC strongly recommend to test the product
configuration and performance before putting it in
the final installation site.
6.1 Installation options
The product can be installed with different brackets
and supports. Remember to exclusively use brackets
and accessories approved for installation.
The housing can be installed with a slope that varies
between ± 90° with reference to the horizon.
6.1.1 Parapet mounting
First of all secure the base of the adapter to the final
destination. Use screws that can bear at least 4 times
the weight of the unit.
Apply a generous amount of thread locking
compound (Loctite 270).
Tighten the screws.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
It's possible to secure the base (01) to the column
adapter NXFWBT using 4 countersunk screws (02)
provided.
Secure the joint (03) to the base through nuts and
washers supplied.
03
02
01
Fig. 3
MNVCMHX_2222_EN