Videotec MAXIMUS MHX Manuel D'instructions page 26

6.10 Connection of the camera to
the power supply
Incorrect wiring can irreparably damage
the camera.
The power supply terminal can host cables
with the characteristics outlined below.
Nominal section of the cables used:
1.5mm² (15AWG).
To identify the product model, consult the
relevant chapter (4.8 Model identification,
page 13).
To connect the power supply use the removable
terminals supplied.
Carry out the wiring according to the camera's
power supply voltage: 12Vdc o 24Vac, 120Vac o
230Vac.
6.10.1 Connection of the camera power
supply in 24Vac and 12Vdc for MHX
without wiper
In these versions the input voltage will be
the voltage of the camera/lens.
Pull out the removable terminal (J7, connectors
board). Carry out the wiring between the terminal
connector and the camera's power supply terminals.
Re-insert the terminal into the connector.
J7
Fig. 28
24
6.10.2 Connection of the camera power
supply in 120Vac and 230Vac for MHX
without wiper
In these versions the input voltage will be
the voltage of the camera/lens.
Pull out the removable terminal (J6, connectors
board). Carry out the wiring between the terminal
connector and the camera's power supply terminals.
Re-insert the terminal into the connector.
J6
Fig. 29
MNVCMHX_2222_EN