Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
9 Operating and setting up the switchgear
9.1 Switching on
The switchgear does not have a separate on/off
switch. It is switched on when the power supply is
switched on.
• Switch on the power supply.
The software status display will appear on the dis-
play screen for 10 seconds. The unit will then
begin to operate according to the current system
pressure.
9.2 Menu navigation
The switchgear (Fig. 2) is set and operated using a
variety of menus.
You use three buttons to access the menus. This is
what they do:
Go back
Go forward
Confirmation (OK button)
Button sequence
→
→
etc.
→
→
→
→
→
The individual menus are shown and described in
section 9.3.
NOTE: If no button at all is pressed on the switch-
gear for 15 minutes, the display switches off.
Pressing the confirmation button
vate the display.
26
Description of the programming steps
The main menus appear in the sequence 1, 2, 3, (4), 5
Select main menu (1, 2, 3, 4 or 5)
1 The sub-menu appears, e.g. 1.01 with the parameters in >....<
2 >....< changes to *....*
3 Change to the new parameter
4 The new parameter is saved; *....* changes to >....<
5 Move on to the next sub-menu. Once you have gone through all sub-menus, pressing the "OK
button" in menu x.99 takes you back to the main menu.
will re-acti-
When the green LED is lit, the unit is ready for use.
If the LED is flashing, parameter input mode is
active.
Parameters in menus 1 and 5 can be changed
without entering a password.
The following menus can also be viewed:
• 2.01 Software version
• 2.07 Height of the overflow
• 3.01 Hours of operation of the pump
• 3.02 Hours of rainwater operation
• 3.03 Hours of potable water operation
Other menus must be enabled by entering a pass-
word (see section 9.1).
To use the menus, press the buttons in the follow-
ing sequence:
WILO SE 01/2009
Publicité
Table des Matières
