Connecting The Door Station - SOMFY V100+ Notice D'installation Et D'utilisation

EN

5.1 Connecting the door station

5.1.1 To a Somfy gate motorisation
Note: When the motorisation is solar-powered, the wired controls are deactivated. In this case, you must use the monitor's wireless control to control
your gate motorisation (see page 12).
[1]. Disconnect the motor from the mains power supply.
[2]. Remove the cover from the control cabinet or from the motor containing the electronics.
[3]. Connect the door station dry contact output (COM and NO) to the motorisation electronics. It is best to consult the gate motorisation instructions
to connect the door station to the key contact input on the motorisation.
Door station
M- M+ L- L+ NO COM NC
Connect...
COM
NO
Note: To connect the door station to another brand of gate motorisation, please refer to the installation guide for that motorisation.
5.1.2 To a door-opener/electric lock
Connect the door station output
lock as shown in the diagram below.
Observe the +/- polarity if indicated in the door latch/lock
instructions.
9
to the START
terminals
5
6
to the latch /
* not provided
Somfy motorisations electronics
to the BUS
terminals
3
4
L- L+
Video phone V100+
to the numbered terminals
3
5 (for complete opening)
or
6 (for pedestrian opening)
12V 800 mA max
Copyright © 2019 SOMFY ACTIVITES SA. All rights reserved.
*